........................................................................................................................................................................................................................

Verify with an ohmmeter that the 1665 DMX High-Capacity shelf is grounded to the bay

frame. Measure between the 1665 DMX High-Capacity shelf mounting bracket and the

office ground lug on the bay frame.

Requirement: The ohmmeter reads less than 1 ohm.

If the Ohmmeter reading is not less than 1 ohm, a secondary ground should be used for

each shelf. Use an 8 AWG wire from the UL (Green M5 Screw) safety ground on the side

of the shelf to bay frame or office ground.

Important!

connected to the bay and to apply no-ox before connecting the wire.

Check off the appropriate box in

N D

........................................................................................................................................................

365-372-304R7.1

Issue 1, November 2007

It is important to remove the paint in the area where the wire is to be

T E P S

Appendix E, "Installation

1665 DMX High-Capacity shelf installation

checklist".

1 - 1 3

Table of Contents