Ds3/Ec1 And 48Tmux Cable Routing - Alcatel-Lucent 1665 Installation Manual

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)
Figure 1-15 DS3/EC1 and 48TMUX cable routing
Important!
........................................................................................................................................................................................................................
Route the cables along the cable rack and into the terminating bay (DSX or other
5
terminating transmission equipment).
........................................................................................................................................................................................................................
Cut the cables to desired length and install the BNC connectors shipped with the cable
6
assemblies.
Important!
carefully to ensure a proper connection. Failure to do so may result in faulty DS3
signals as a result of improperly installed BNC connectors.
........................................................................................................................................................................................................................
Connect the cables to their respective positions on the terminating equipment.
7
Important!
based on the circuit pack not the backplane. There is no issue interchanging these
cables on the backplane. The Signals are common between both cables.
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
This figure shows DS3 cabling for FNA and FNB.
When installing BNC connectors, follow the manufacturer's instruction
The 12 port cable and the 24 port cable use different signal grounds
DS3/EC1 and 48TMUX cable installation
1 - 4 3