Alcatel-Lucent 1665 Installation Manual page 34

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)
Quantity
1
1
______________________________________________________________
* Registered trademark of Thomas & Betts Corporation
† Registered trademark of Paladin Corporation.
Mounting options
The mounting brackets on the 1665 DMX High-Capacity shelf are designed to allow for
mounting in the following:
Standard 23-inch wide network bay frames
•
The recommended network bay frames are the ED-8C500 and the ED-8C501 (rear
access only). Refer to
mounting arrangements" (p. 1-12)
frame.
Seismic 23-inch network bay frame
•
The ED-8C800-500 and ED-8C801-501 seismic network bay frames are designed for
use in all earthquake zones, and in general, do not require top support at the 7-foot
level. These frames meet Pacific Bell Equipment Framework Standard PBS-000-
102PT.
19-inch bay frames
•
23-inch wide EIA-Type bay frames
•
1665 DMX added to the Lambda Unite
In order for the 1665 DMX shelf to be placed in a NEBS-2000 Cabinet frame combined
with Lambda Unite
view of mounting the 1665 DMX into the Lambda Unite
1665 DMX
Cabling checklist
This section briefly describes cabling information. For information regarding available
cable lengths and ordering comcodes, refer to ED8C871-10.
Table 1-1, "Cable requirements and options" (p. 1-5)
............................................................................................................................................................................................................................................................
1 - 4
Description
Torque Wrench
ITE-5952
Ohmmeter ITE-6379
Figure 1-4, "Typical 1665 DMX High-Capacity shelf bay
®
MSS configurations
®
MSS, mounting kit 848856514 is required. For a more complete
added to the Lambda Unite
Comments
A torque wrench (50-250 IN-LBS) is used when
tightening the 1665 DMX High-Capacity shelf to
the frame. It is also used when reattaching the
mounting brackets to the 1665 DMX High-Capacity
shelf.
An ohmmeter is required to verify that the 1665
DMX is properly grounded.
for 1665 DMX shelf placement in a network bay
®
Frame, see SIG-L-WW-161A,
®
MSS Configurations.
lists available cables.
Planning
365-372-304R7.1
Issue 1, November 2007