Alcatel-Lucent 1665 Installation Manual page 158

Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
LNW70 (100/1G FXS), LNW74 (10/100 T/F), LNW63 (1000BASE-SX/LX/LX10), LNW64 (8 GbE),
LNW78 (RPR) and LNW170 (100/1G FXS) installation (optional)
Follow this procedure only if installing LNW70 (100/1G FS), LNW74 (10/100 T/F),
LNW63 (1000BASE-SX/LX/LX10), LNW64 (8 GbE), LNW78 (RPR) and LNW170
(100/1G FXS) circuit packs into the 1665 DMX shelf.
Important!
packs require SFP modules for the Ethernet interface. This procedure will consist of
two parts. Installing the circuit card and installing the SFP per
transmission modules (p.
........................................................................................................................................................................................................................
Refer to the engineering job specification. Identify the proper function group slot (A1, A2,
1
B1, B2, C1, C2, D1, D2, G1 or G2) where the LNW70, LNW74, LNW63, LNW64,
LNW78 or LNW170 circuit pack will be installed.
Important!
optical 100 Base-F ports are available for use.
The LNW70, LNW74, LNW63, LNW64, LNW78 and LNW170 circuit packs can
only be installed in slot 1 of any function group unless the mains are equipped with
LNW59 or LNW82 (VLF) main circuit packs. With the LNW59 and LNW82 mains,
all fn slots may be equipped.
........................................................................................................................................................................................................................
Remove the LNW70, LNW74, LNW63, LNW64, LNW78 or LNW170 from the packing
2
material.
........................................................................................................................................................................................................................
3 Place the circuit pack into the shelf fn slot. Do NOT engage the circuit pack in the
backplane connector.
........................................................................................................................................................................................................................
Install a blank circuit pack into the companion fn circuit pack slot as required.
4
Important!
for cooling.
........................................................................................................................................................................................................................
Repeat
5
LNW70, LNW74, LNW63, LNW64, LNW78 or LNW170 circuit packs.
............................................................................................................................................................................................................................................................
2 - 2 8
The LNW70, LNW74, LNW63, LNW64, LNW78 and LNW170 circuit
When LNW74 is installed in the G1 or G2 position, only the faceplate
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
2-34).
for each additional function group to be equipped with
Initial circuit pack installation
Install pluggable
365-372-304R7.1
Issue 1, November 2007