Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)
Power cable and cable bracket installation
............................................................................................................................................................................................................................................................
Description
This section provides instructions on installing the power cable and cable bracket for the
1665 DMX High-Capacity shelf.
Important!
board (BDFB) or battery distribution circuit breaker bay (BDCBB) to the 1665 DMX
bay.
Table 1-2, "Power cable assemblies" (p. 1-25)
(p. 1-26)
Procedure
Proceed as follows:
........................................................................................................................................................................................................................
Install cable brackets (two per 1665 DMX High-Capacity shelf, 1 on each side) as shown
1
in
Figure 1-6, "Cable brackets" (p.
............................................................................................................................................................................................................................................................
1 - 1 6
Two feeders (A and B) are required from the battery distribution fuse
list the available power cable assemblies and power connections, respectively.
CAUTION
Verify that the BDCBB breakers are off or that the BDFB fuses are
not installed.
Power cable and cable bracket installation
and
Table 1-3, "Power connections"
1-17).
365-372-304R7.1
Issue 1, November 2007