............................................................................................................................................................................................................................................................

Fiber management installation (optional)

Description

This section describes how to install the fiber management pieces that may be shipped

with the bay.

Note:

extended by at least 2.5 inches beyond the bay upright on each side. This is typically

done using base fillers.

Comcode numbers are in parentheses next to the part number.

Procedure

Locate three spools (106738156), one fiber radius control module (321-1B), one left fiber

spool bracket (848919213) and three M4 X 6 bracket mounting screws (901340059) for

each shelf being installed.

For each spool, put a nylach fastener through the middle. Then insert a pin halfway

through.

Note:

the fastener and prevent it from being assembled to the bracket.

Line up the nylach fastener in one of the spools with the large holes on the top arm of the

bracket.

365-372-304R7.1

Issue 2 March 2008

If fiber management is to be installed, the width of the bay footprint must be

It is very important that the pin is not completely inserted. This will deform

Fiber management installation (optional)

1 - 2 7

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Fiber Management Installation (Optional) - Alcatel-Lucent 1665 Installation Manual