Cit Cable Installation - Alcatel-Lucent 1665 Installation Manual

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)

CIT cable installation

............................................................................................................................................................................................................................................................
Description
This section provides the procedure to connect the CIT cable from the LNW2 (SYSCTL)
to a PC (serial port). This will allow communications between the PC and the CIT port
located on the LNW2.
Procedure
........................................................................................................................................................................................................................
Connect the RJ45 end of the CIT cable to the CIT jack located on the LNW2 (SYSCTL).
1
Refer to
Important!
here to demonstrate the placement of the cable once the circuit pack is in place.
........................................................................................................................................................................................................................
Connect the 9-pin D-type connector to the serial port on the PC.
2
............................................................................................................................................................................................................................................................
1 - 9 6
Figure 1-28, "CIT cable installation" (p.
The LNW2 (SYSCTL) is not in the shelf at this time, this procedure is
1-97).
CIT cable installation
365-372-304R7.1
Issue 1, November 2007