JLG 1200SJP Service Maintenance Manual page 395

Table 6-2. Machine Configuration Programming Information - Version P7.X to Present
Configuration Digit
GEN SET/WELDER:
10
GEN SET CUTOUT:
11*
* Only visible if Gen Set / Welder Menu selection is not 0.
H & T LIGHTS:
12
LOAD SYSTEM:
13*
* Only visible under certain market selections.
* Certain market selections will limit load system options or alter default setting.
3121142
Number
0 NO: No generator installed.
1 BELT DRIVE: Belt driven setup.
2 HYDRAULIC DRIVE: Hydraulic driven setup.
0 MOTION ENABLED: Motion enabled when generator is ON.
1 MOTION CUTOUT: Motion cutout in platform mode only.
0 NO: No head and tail lights installed.
1 YES: Head and tail lights installed.
0
NO: No load sensor installed.
1
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
2
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform alarm beeps (5
sec ON, 2 sec OFF).
3
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main lift up, platform
alarm beeps (5 sec ON, 2 sec OFF).
4
Description
– JLG Lift –
SECTION 6 - JLG CONTROL SYSTEM
1
0
0
0
Default
Number
6-19