Dtc 336- Crank Signal Input Noise - JLG 1200SJP Service Maintenance Manual

Hide thumbs Also See for 1200SJP:
Table of Contents

Advertisement

SECTION 3 - CHASSIS & TURNTABLE

DTC 336- Crank Signal Input Noise

• Crankshaft Position sensor
• Check Condition- Key On, Engine On
• Fault Condition- Electrical noise or irregular crank pattern
detected causing x number of crank resynchronization
events as defined in the diagnostic calibration
• Corrective Action(s)- Illuminate MIL and/or sound audible
warning or illuminate secondary warning lamp and disable
adaptive fueling correction for remainder of key-cycle.
• Emissions related fault
The crankshaft position sensor is a magnetic sensor (variable
reluctant/magnetic pick-up or halleffect) installed in the
engine block adjacent to a "coded" trigger wheel located on
the crankshaft. The sensor-trigger wheel combination is used
to determine crankshaft position (with respect to TDC cylinder
#1 compression) and the rotational engine speed. Determina-
tion of the crankshaft position and speed is necessary to prop-
erly activate the ignition, fuel injection, and throttle governing
systems for precise engine control.
3-150
W H IT E /P U R P LE
2
1 P U R P LE /W H IT E
The ECM must see a valid crankshaft position signal while run-
ning. If no signal is present, the signal amplitude is too high
(due to improper air gap with respect to trigger wheel), or an
irregular crank pattern is detected causing the ECM to resyn-
chronize x times for y ms or longer as defined in the diagnostic
calibration, this fault will set. Irregular crank patterns can be
detected by the ECM due to electrical noise, poor machining
of trigger wheel, or trigger wheel runout and/or gear lash.
Ensure crank circuit used with VR/magnetic pick-up sensors
are properly twisted.
– JLG Lift –
P U R P LE /W H IT E
W H IT E /P U R P LE
3121142

Advertisement

Table of Contents
loading

This manual is also suitable for:

1350sjp

Table of Contents