JLG 1200SJP Service Maintenance Manual page 417

Diagnostics Submenu
Parameter (Displayed on
(Displayed on Analyzer
Analyzer 2
st
1 Line)
OSC AXLE P SW
SKY WELDER
SKY CUTTER
SKY GLAZIER
SKY BRIGHT
PIPE RACKS
CAMERA MOUNT
LOAD:
LENGTH
ANGLE
WEIGHT
3121142
Table 6-5. Machine Diagnostics Parameters
Parameter Value
nd
Line) (Displayed on Analyzer 2
OP/CL
YES/NO
YES/NO
YES/NO
YES/NO
YES/NO
YES/NO
OP /CL
OP / CL
XXXX%
OK/OVERLOADED
– JLG Lift –
SECTION 6 - JLG CONTROL SYSTEM
nd
Line)
Displays status of oscillating axle pressure switch. (Displayed if OSCILLATING
AXLE = 1)
Displays the status of Sky Welder selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Sky Cutter selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Sky Glazier selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Sky Bright selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Pipe Racks selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Camera Mount selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Not displayed if LOAD=NO, LENGTH=NO, and ANGLE=NO (machine digits =
0)
Displays measured length, NOTE: Not displayed if MODEL NUMBER = 7 or 8
Displays measured angle, NOTE: Not displayed if MODEL NUMBER = 7 or 8
Percentage of maximum calibrated weight on the platform. An uncalibrated
load cell will read 1000% Displayed if LOAD is not 0 and LOAD TYPE is 0.
Displayed if LOAD is not 0 and LOAD TYPE is 1.
Description
6-41