Inspection; Assembly - JLG 1200SJP Service Maintenance Manual

Hide thumbs Also See for 1200SJP:

Table of Contents

Inspection

1. Clean all parts in a solvent tank and dry with com-

pressed air prior to inspecting. Carefully inspect all criti-

cal areas for any surface finish abnormalities: Seal

grooves, bearing grooves, thrust surfaces, rod surface,

housing bore and gear teeth.

2. Inspect the thrust washers (304) for rough or worn

edges and surfaces. Measure it's thickness to make sure

it is within specifications (Not less than 0.092" or 2.34

3. Inspect the wear guide condition and measure thick-

ness (not less than 0.123" or 3.12 mm).

1. Gather all the components and tools into one location

prior to re-assembly. Use the cut away drawing to refer-

ence the seal orientations.

– JLG Lift –

SECTION 4 - BOOM & PLATFORM

Table of Contents