Dtc 1628- Can Address Conflict Failure - JLG 1200SJP Service Maintenance Manual

Hide thumbs Also See for 1200SJP:

Table of Contents

SECTION 3 - CHASSIS & TURNTABLE

DTC 1628- CAN Address Conflict Failure

• CAN device(s)

• Check Condition- Key On, Engine on

• Fault Condition- two or more devices on the network that

contain the same SA

• Corrective Action(s)- Sound audible warning or illuminate

secondary warning lamp

• Non-emissions related fault

BL U E /R E D or P IN K

BLU E /W H IT E

The Controller Area Network serves as a communication portal

between intelligent devices. These devices may be but are not

limited to other engine ECMs (slave), diagnostic tools, "smart"

gauges, "smart" sensors, powertrain control units, vehicle con-

trollers, actuators, etc. The network permits several devices to

communicate with each other receiving and broadcasting

commands as programmed. This type of network allows

devices to be added to an entire system through only two con-

ductors and permits all other devices to broadcast and receive

commands to and from the device when properly com-

This fault indicates that there are two (2) or more devices on

the network that use the same source address.

– JLG Lift –

Table of Contents