15. Hit Enter. The screen will read:
16. Repeat steps 10 thru 12 for the Tele In function.
17. After completing all the Tele Calibrations, hit ESC twice
to go back to CALIBRATIONS.
3121142
6.18 CALIBRATING TILT SENSOR
A NEW TILT MODULE WILL ACT AS IF IT IS TILTED ALL OF THE TIME UNTIL THE
FOLLOWING PROCEDURE IS PERFORMED.
DO NOT CALIBRATE THE LEVEL SENSOR EXCEPT ON A LEVEL SURFACE.
1. Use the following procedure to calibrate the tilt sensor.
Before the tilt sensor can be calibrated, the following
conditions must be met:
a. Steering previously calibrated.
b. Axles extended.
c. Wheels straight.
d. Turntable centered.
e. Boom fully retracted.
f. Boom angle is less than 45°.
g. Machine on firm, level ground.
2. Position the Platform/Ground select switch to the
Ground position.
– JLG Lift –
SECTION 6 - JLG CONTROL SYSTEM
6-65