JLG 1200SJP Service Maintenance Manual page 418

SECTION 6 - JLG CONTROL SYSTEM
Diagnostics Submenu
Parameter (Displayed on
(Displayed on Analyzer
Analyzer 2
st
1 Line)
MOMENT:
(LB-IN) ACTUAL
(LB-IN)
OVER
(LB-IN)
UNDER
CAL PT
UNDER
CAL PT
WIT YEL
CAL PT
WIT GRN
CYL PIN
RATIO
PIN
E FLAGS
SKY WELDER
SKY CUTTER
SKY GLAZIER
SKY BRIGHT
PIPE RACKS
CAMERA MOUNT
6-42
Table 6-5. Machine Diagnostics Parameters
Parameter Value
nd
Line) (Displayed on Analyzer 2
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
XXXXXXXX
X.XXX
0xXXXX
YES/NO
YES/NO
YES/NO
YES/NO
YES/NO
YES/NO
– JLG Lift –
nd
Line)
Displayed if MODEL NUMBER = 7 or 8
Displays current moment value
Displays current over moment setpoint.
Displays current under moment setpoint.
Displays the under moment value recorded during boom sensor calibration.
Displays the yellow witness mark moment value recorded during boom sen-
sor calibration.
Displays the green witness mark moment value recorded during boom sensor
calibration.
Displays the current cylinder moment pin ratio of X and Y forces.
Displays the current error flag status of the cylinder moment pin.
Displays the status of Sky Welder selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Sky Cutter selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Sky Glazier selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Sky Bright selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Pipe Racks selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Displays the status of Camera Mount selected during boom sensor calibration.
(Displayed if MODEL NUMBER = 7 or 8)
Description
3121142