Table of Contents
Advertisement
1. Slotted Nut
2. Cotter Pin
6.10 DIAGNOSTIC TROUBLE CODES (DTC)
The DTC codes listed in the following table are not a complete listing of machine
DTC codes. This listing shows only those DTC's which an operator may be able to
correct due to operating error.
The DTC table following is sorted in groups by the first two digits, these digits represent
the number of flashes the system distress indicator lamp will flash on the platform
indicator panel when a fault occurs.
The more detailed three to five digit code numbers in the DTC column of the following
tables are only indicated on a JLG handheld diagnostic analyzer connected to the
machine, or on the Ground Control Station - MDI indicator, if equipped.
To troubleshoot multiple DTC's, start with the DTC with the higher first two digits.
If a correction is made during a check, conclude the check by cycling the machine
power off then back on, using the emergency stop switch.
Should a fault occur which cannot be corrected by the operator, the problem must
be referred to a mechanic qualified to repair this model of JLG lift.
R4045
General Specifications and Operator Maintenance
3. Wheel and Hub Assembly
4. Tapered Shaft
NOTICE
NOTICE
31221538
5. Shaft Key
113
Advertisement
Table of Contents
