Manitowoc Grove TMS700E Service And Maintenance Manual page 261

TMS700E SERVICE MANUAL
Steering
Gearbox
35.6 mm (1.40 in)
Max. Exposed
Threads Allowed
Drag Link (Detail #7)
Setting Axle Stops and Steering Gear Relief Plungers
1. Start the engine and run at idle.
2. With the wheels on greased plates, turn the wheels in
both directions and check for clearances between all
moving parts. The clearances should be at least 1.00 in
(25 mm).
Grove
Drag Link
(Detail #6)
Front Relay Arm
(Detail #9)
6.4 mm (0.25 in)
Align Clamp With
Slot In Tube
Published 01-29-2015, Control # 512-01
Front Relay Arm
Rig Pin
Drag Link
(Detail #7)
Drag Links (Detail #5)
43.4 mm (1.71 in)
Max. Exposed
Threads Allowed
Drag Links (Detail #5 & #6)
3. Adjust the axle stop as necessary to get the maximum
cramp angle and proper clearances.
4. Put the full weight of the machine on properly inflated
tires and on a hard firm surface.
UNDERCARRIAGE
Rear Relay Arm
Rig Pin
Rear Relay Arm
(Detail #8)
6.4 mm (0.25 in)
Align Clamp with
Slot in Tube
FIGURE 8-5
8
8-9