Table of Contents
Advertisement
|
|
|
|
|
|
Complete the following steps to install hot-swap hard disk drives in the expansion
enclosure.
Attention:
After you remove a drive CRU, wait 70 seconds before replacing or
reseating the drive CRU to allow the drive to properly spin down. Failure to do so
may cause undesired events.
1. Before you insert the new SATA drive option or drive CRU/FRU into the DS4000
configuration, you must ensure that the installed DS4000 controller and EXP100
ESM have the minimum controller and ESM firmware versions that are required
for the new SATA drive. Always check the documentation that is included with
the new drive to find out the minimum controller and ESM firmware versions, or
any prerequisite tasks, for DS4000 controller and EXP100 ESM.
2. Check for Fault LEDs shown in Figure 43. If any amber LEDs are lit, see
"Solving problems" on page 99.
Fault LED
Activity LED
Tray handle
Latch
Figure 43. Hot-swap hard disk drive LEDs
3. Determine the bay into which you want to install the drive.
4. Remove the blank tray:
a. Release the latch on the drive CRU by pinching together the blue line on the
tray latch and the finger hole on the tray handle, as shown by the arrow in
Figure 43.
b. Pull the handle on the tray out so that it is in the open position to release
the drive CRU, and then pull the blank tray out of the bay.
c. Save the blank tray for later use.
5. Install the hard disk drive:
Note: The hard disk drive comes installed in a drive tray. Do not attempt to
detach the drive from the tray.
a. Release the latch on the drive CRU by pinching together the blue line on the
tray latch and the finger hole on the tray handle.
b. Pull the handle on the tray out so that it is in the open position, as shown in
Figure 44 on page 76.
Power-on LED
Chapter 3. Installing and replacing devices
General system
error LED
75
Advertisement
Table of Contents
Troubleshooting
