Setting Up The Enclosure And Installing A Drive - IBM 1 U Installation Manual

Setting up the enclosure and installing a drive

Notes:
1. You can use a SAS accessory kit to install either a SAS drive or a SATA drive in
2. You can use the USB accessory kit to install either a USB drive or a SATA drive
3. You need an accessory kit for each tape drive that you install in the enclosure.
To set up the tape enclosure and install a drive, complete the following steps.
Note: You will need a flat-blade screwdriver and a Phillips screwdriver during the
installation.
8
IBM 1 U Rack Mount Tape Enclosure: Installation Guide
the tape drive enclosure.
in the tape drive enclosure.
1.
Review the information in "Safety" on page iii, "Installation guidelines for rack
mount enclosures" on page 7, and the safety documentation that comes with
your rack cabinet.
2.
Loosen the thumbscrew on the back of the enclosure; then, remove the
cover from the enclosure.