Installing Hot-Swap Hard Disk Drives; Hot-Swap Hard Disk Drive Leds - IBM TotalStorage DS4000 EXP700 Installation, User's, And Maintenance Manual

Installing hot-swap hard disk drives

You can install hard disk drives while the storage expansion enclosure is turned on
and running. Complete the following steps to install hot-swap hard disk drives in the
storage expansion enclosure.
1. Read the documentation that comes with the hard disk drive.
2. Check for Fault LEDs shown in Figure 52. If any amber LEDs are lit, see
Figure 52. Hot-swap hard disk drive LEDs
3. Determine the bay into which you want to install the drive.
4. Remove the blank tray:
5. Install the hard disk drive:
68
IBM TotalStorage DS4000 EXP700 and EXP710 Storage Expansion Enclosures: Installation, User's, and Maintenance Guide
Chapter 4, "Hardware maintenance," on page 77.
General system
error LED
Enclosure
Power-on LED
Identity LED
Tray handle
a. Insert a finger into the square hole at the top of the blank tray to grip and
pull the tray out of the drive bay.
b. Save the blank tray for later use.
Note: The hard disk drive comes installed in a drive tray. Do not attempt to
detach the drive from the tray.
a. Release the blue latch on the drive CRU by pressing on the inside of the
bottom of the tray handle.
Bezel
Latch Fault LED Activity LED
Blank tray
Drive CRU