Step 3. Install Front Wheels - MacDon M105 Assembly Instructions Manual

STEP 3. INSTALL FRONT
WHEELS
a. Support the front of the windrower off the ground
with stand(s).
b. Position wheel against hub so that air valves are
on outside, and tire tread points forward.
For "Turf" tires (diamond tread), be sure arrow
on sidewall points in forward rotation.
c. Lift wheel on hub with a forklift (or equivalent).
Lower forklift.
d. Rotate wheel to align holes with studs, and push
wheel onto studs.
Form 169558
UNLOADING AND ASSEMBLY
13
6
3
8
e. Install wheel nuts, and tighten to 175 - 200 ft∙lbf
(237 - 271 N∙m), using the tightening sequence
shown above.
To avoid damage to wheel disks, do
not over-tighten wheel nuts.
f. Repeat sequence three times.
g. Repeat above steps b. to f. for opposite wheel.
h. Remove stand(s), and lower windrower to
ground.
BOLTED FRAME SHIPPING SKID
BOTH SIDES
i. Remove bolt and shipping skid on LH and RH
leg. Discard.
j. For Bolted Frame windrower, proceed to
STEP 5. RE-POSITION CASTER WHEELS
(Bolted Frame)
k. For Fixed Beam
STEP 4. INSTALL CASTER WHEELS (Fixed
Frame).
1
4
7
2
5
NOTE
windrower, proceed
Revision A
to