Table of Contents
Advertisement
STEP 3. INSTALL FRONT
WHEELS
a. Support the front of the windrower off the ground
with stand(s).
b. Position wheel against hub so that air valves are
on outside and tire tread point forward.
"Turf" tires (diamond tread), be sure arrow on
sidewall points in forward rotation.
c. Lift wheel on hub with a forklift or equivalent.
Lower forklift.
d. Rotate wheel to align holes with studs and push
wheel onto studs.
Form # 169390
UNLOADING AND ASSEMBLY
e. Install wheel nuts and tighten to 175-200 ft·lbf
f.
g. Repeat above steps b. to f. for opposite wheel.
h. Remove stand(s) and lower windrower to
i.
j.
For
k. For Fixed Beam windrower, proceed to STEP 4
13
6
3
8
5
(237-271 N·m) using the tightening sequence as
shown.
NOTE
To avoid damage to wheel disks, do
not over-tighten wheel nuts.
Repeat sequence three times.
ground.
BOLTED FRAME SHIPPING SKID
BOTH SIDES
Remove bolt and shipping skid on LH and RH
leg. Discard.
For Bolted Frame windrowers, proceed to STEP
5. REPOSITION CASTER WHEELS
INSTALL CASTER WHEELS.
1
4
7
2
Model Year - 2010
Advertisement
Table of Contents
