MacDon M105 Assembly Instructions Manual page 26

O
F
j. Install pin (F) through header leg, (engaging
U-bracket in lift linkage) on both sides, and
secure with hairpin.
NOTE
Install hairpin with open end facing "aft".
k. Raise header stand (N) to storage position by
pulling pin (O), and lifting stand into uppermost
position. Release pin (O).
l. Remove pin from storage position (P) in linkage,
and insert in hole (Q) to engage float springs.
Secure with hairpin.
m. Disengage lift cylinder stops by turning lever (L)
away from header to raise cylinder stop until
lever locks into vertical position. Repeat for both
cylinder stops.
Form 169558
UNLOADING AND ASSEMBLY
N
P
Q
L
n. Start engine, and activate HEADER LIFT
cylinders (switch on GSL) to lower header fully.
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
o. Stop engine, and remove key.
S
p. Connect header drive hoses (R) and electrical
harness (S) to header.
Header Operator's Manual.
REEL HYDRAULICS
q. Connect reel hydraulics (T) at RH side of
windrower. Refer
Operator's Manual.
24
R
HEADER DRIVE HOSES
Refer to the Draper
T
to the Draper Header
Revision A