MacDon M105 Assembly Instructions Manual page 30

i. Remove lynch pin from pin (M) in stand (N).
j. Hold stand (N) and remove pin (M).
k. Re-position stand to "storage position" by
inverting stand, and re-locating on bracket as
shown. Re-insert pin (M), and secure with lynch
pin.
l. Remove pin (O) from "storage position" in
linkage, and insert in hole (P) to engage float
springs. Secure with lynch pin.
m. Disengage lift cylinder stops by turning lever (J)
away from header to raise cylinder stop until
lever locks into vertical position. Repeat for both
cylinder stops.
n. Start engine, and activate HEADER LIFT
cylinder switch on GSL to lower header fully.
o. Stop engine and remove key.
Form 169558
UNLOADING AND ASSEMBLY
N
M
O
P
J
p. Connect header drive hydraulics (Q) and
electrical harness (R) to header. Refer to Auger
Header Operator's Manual.
28
R
Q
Revision A