MacDon M105 Assembly Instructions Manual page 29

DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header, and before going under the header
for any reason.
g. Cylinder stops are located on both header lift
cylinders on the windrower. Engage lift cylinder
stops on both lift cylinders as follows, and
proceed to step h. in next column.
HEADER DOWN
1. Press HEADER UP switch to raise header to
maximum height.
If one end of the header does not
raise fully, the lift cylinders require
re-phasing.
If re-phasing is needed, proceed as
follows:
i. Press and hold HEADER UP switch until
both cylinders stop moving.
ii. Continue to hold switch for 3 - 4
seconds.
iii. Cylinders are phased.
Form 169558
UNLOADING AND ASSEMBLY
HEADER UP
NOTE
2. Pull lever (J), rotate toward header to
release, and lower cylinder stop (K) onto
cylinder. Repeat for both lift cylinders.
h. Install pin (L) through each boot and foot and
secure with hairpin.
Ensure pin (L) is fully inserted, and
hairpin is installed behind bracket.
27
J
K
L
IMPORTANT
(continued next page)
Revision A