Step 2. Re-Position Rh Leg (Bolted Frame) - MacDon M105 Assembly Instructions Manual

STEP 2. RE-POSITION RH LEG
(BOLTED FRAME)
For a Fixed Frame windrower, proceed to
STEP 3. INSTALL FRONT WHEELS.
For a Bolted Frame windrower, only the right
cab-forward leg requires re-positioning from
shipping to field configuration as follows:
a. Support front of the windrower leg off the ground
with stand (or equivalent).
b. Position jack under RH leg, and raise jack
slightly to take some weight off leg.
c. Remove two bolts, washers, and nuts from
frame.
Form 169558
UNLOADING AND ASSEMBLY
d. Tap out the two pins with a hammer.
e. Move leg out to expose one hole.
f.
g. Lower jack, and remove it from RH leg.
12
Re-install pins, and secure with bolts, washers,
and nuts (not shown). Torque nuts to 100 ft∙lbf
(136 N∙m).
Revision A