Step 7. Install Wheels - MacDon A30-S Unloading And Assembly Instructions

STEP 7. INSTALL WHEELS
a. Remove wheel bolts from wheel hub.
CAUTION
When installing wheel be sure to use the
holes that are countersunk to match bolt
head profile. The non-countersunk holes do
not seat the bolts correctly.
B
b. Install wheels (A) with existing bolts. Be sure
valve stem (B) points away from wheel support.
6
4
2
c. Torque bolts to 120 ft·lbf (160 N·m), following
tightening sequence shown above.
IMPORTANT
Follow proper bolt tightening sequence
shown above.
d. Raise aft end of header with forklift so that
blocks (C) under lower links can be removed.
Chain may also be used at hook (D).
e. Lower header onto wheels.
169001
UNLOADING AND ASSEMBLY
D
A
C
1
3
5
f. Check tires are inflated to 30 psi (207 kPa).
MAST PERPENDICULAR
ADJUST HEIGHT
AS REQUIRED
WITH BLOCKS
g. Check that frame is sitting at proper angle, with
APT pivot pin mounting hole perpendicular to
ground. Adjust height of blocks as required.
13
TO GROUND
Revision E