MacDon M105 Assembly Instructions Manual page 47

VII. OPERATOR'S PRESENCE SYSTEM
CHECKS
a. With the windrower engine running, place the
GSL in NEUTRAL, and turn the steering wheel
until it locks.
CAUTION
Check to be sure all bystanders have
cleared the area.
b. With everyone clear of the machine, engage
HEADER DRIVE switch.
1. After header drives are running, stand up
out of the seat. In approximately 5 seconds
the header should shut off. If not, the
Operator Presence
adjustment, refer to the M105 Operator's
Manual for adjustment procedures.
To restart the header, move the
HEADER DRIVE switch to the OFF
position, and back to the ON position
again.
c. With the windrower moving at less than 3 mph;
1. Stand up out of the seat.
2. The CDM will flash "NO OPERATOR" on the
upper line, and "ENGINE SHUTDOWN
5...4...3...2...1...0"
accompanied by a steady tone. At "0", the
engine shuts down.
3. If the engine does not shut down, the
Operator Presence
adjustment, refer to the M105 Operator's
Manual for adjustment procedures.
d. With the windrower moving at more than 3 mph;
1. Stand up out of the seat.
2. The CDM beeps once, and displays "NO
OPERATOR" on the lower line.
3. If not, the Operator Presence System
requires adjustment, refer to the M105
Operator's Manual
procedures.
Form 169558
PRE-DELIVERY CHECKS
System requires
NOTE
on the lower
System requires
for adjustment
VIII. EXTERIOR LIGHTS
a. Switch FIELD lights ON, and check that all lights
as shown are functioning.
line
b. Turn lights OFF.
45
FIELD LIGHTS
FRONT
FIELD LIGHTS
SWATH LIGHTS
REAR
(continued next page)
Revision A