Step 8. Install Batteries - MacDon M105 Assembly Instructions Manual

STEP 8. INSTALL BATTERIES

The batteries should conform to the following
specification:
RATING GROUP CCA
Heavy
Duty, BCI 31A
650
Off-Road, OR
(min)
Vibration 29H
Resistant
a. Open engine compartment hood to highest
position.
C
E
A
b. A battery main disconnect switch is located on
the battery tray. Ensure switch is switched to
Power OFF.
c. Position new batteries on holder (A).
d. Install strap (B) with bolts (C).
Form 169558
UNLOADING AND ASSEMBLY
VOLT MAX. DIMENSION
13 x 7.4 x 9.13 in.
12
(334 x 188 x 232 mm)
D
B
BATTERY
GROUNDED. Always connect starter
cable to the positive (+) terminal of
battery, and battery ground cable to
negative
Reversed
alternator may result in permanent
damage to electrical system.
e. Attach negative (black) cable clamps (D) to
negative post on batteries, and tighten clamps.
f. Attach positive (red) cable clamps (E) to positive
post on batteries, and tighten.
plastic covers onto clamps.
g. Switch battery switch to ON.
h. Close engine compartment hood.
18
IMPORTANT
IS NEGATIVE
(-) terminal of battery.
polarity in battery
Re-position
Revision A
or