Setting Tables - wtw DIQ/S 182-MOD System Operating Manual

System 182
ba75504e07 04/2012

4.3.2 Setting tables

In the setting tables, you make the actual settings. Two lines together
represent each setting. The name of the setting is in the upper line on
the left side of the display. The corresponding value is in the line below
on the right side.
Fig. 4-3 Example of a setting table
Operating notes
 The arrows 8/2 appear if further display settings are above or
below the visible display range.
 With the toggle switch
reverse video) and move the visible display range up or down.
 To edit a setting highlight it and press
highlighted and switches to the entry mode. Depending on the
operating situation, a new submenu or a table with further relevant
settings can open up.
 Break off an action and change to the next higher level with the
key.
 Move directly to the measured value display with
Note
To accept all settings, you have to highlight the Save and quit menu
item at the lower end of the setting table and press
m
setting table via ,
ignored.
Fig. 4-4 Save and quit
w
you highlight a setting (displayed in
e
/Quit or the Quit menu item, all changes are
Operation
g
. The line below is
m
.
g
. If you exit the
e
4 - 5