Table of Contents
Advertisement
System 182
Save and quit
ba75504e07
04/2012
If you want to correct a previously selected character while entering,
select the thin arrow to the left b and press
entry mark by one digit to the left. Thus you can go back to the
required character. All characters on its right side, however, have to
be entered once again.
If you want to restart entering the characters, select the thick arrow
to the left B and press
Numerals:
Entering numerals is made in the same way as entering characters.
The following numerals can be entered: 0..9-.
Entering" -" or "." is only allowed where it makes sense, e.g. "-" at
the first position only.
On principle, all settings done in the entry mode are only taken over
after you selected the Save and quit item in the relevant setting table
g
and pressed
. If you exit the setting table via
menu item, all changes are ignored.
Exceptions: Date/time, air pressure and password.
g
.
Operation
g
. This moves the
m
e
,
or the Quit
4 - 7
Advertisement
Table of Contents
