Linking And Adjusting: General Proceedings; Linking Relay Outputs - wtw DIQ/S 182-MOD System Operating Manual

Relay outputs
Linking options
Proceeding: linking
outputs
6 - 2
6.2

Linking and adjusting: general proceedings

6.2.1 Linking relay outputs

You have the following options of linking relay outputs:
 Sensor S01
The output is linked with sensor 01
 Sensor S01
The output is linked with sensor 02
 Sensor S01&S02
The output is linked to both sensors S01 and S02.
 System
Select this option if you want to use the output for system monitoring
(details, see section 6.4.2).
Proceed as follows if the output was not yet linked. If you want to
change a link you have to erase the existing link first.
1 Open the SETTINGS menu with
w
2 Using and
menu item (corresponding to sensor 1, 2 or 3). A list with all
linking options is displayed.
3 Select the required option with
The output is linked. The link is displayed in the header when
the setting of the output is edited.
s
g
, select and confirm the Relay output Rx
w
System 182
.
g
and confirm with
ba75504e07
.
04/2012