Connecting The Voltage Supply; Diq/S 182-Mod (Line Power Version) - wtw DIQ/S 182-MOD System Operating Manual

System 182
Materials required
ba75504e07 04/2012
3.8

Connecting the voltage supply

Note
The two following paragraphs describe how to connect both models of
the DIQ/S 182-MOD Universal Transmitter to the voltage supply. How
to connect additional power supply modules is described in the
operating manual of the respective power supply module.

3.8.1 DIQ/S 182-MOD (line power version)

Warning
If the power supply is incorrectly connected, it may represent a
danger to life from electric shock. Pay attention to the following
points during installation:
 The DIQ/S 182-MOD Universal Transmitter may only be
connected by a trained electrician.
 The connection of the DIQ/S 182-MOD Universal Transmitter to
the power supply may only be carried out when it is not
carrying any voltage.
 The power supply must fulfill the specifications given on the
nameplate and in chapter 10 T
 When installed in a building, a switch or power switch must be
provided as an interrupt facility for the System 182.
The interrupt facility must
– be installed in the vicinity of the DIQ/S 182-MOD Universal
Transmitter, easily accessible by the user, and
– be labeled as the interrupt facility for the
DIQ/S 182-MOD Universal Transmitter.
 After the DIQ/S 182-MOD Universal Transmitter has been
installed, it may only be opened if the line voltage has been
switched off beforehand.
 Wire end sleeves, suitable for the power line, with suitable crimping
tool
 1 x screwed cable gland with sealing ring (scope of delivery of the
Universal Transmitter).
 Cable stripping knife
Tools
 Wire stripper
 Phillips screwdriver
 Small screwdriver.
.
ECHNICAL DATA
Installation
3 - 29