Switching On The Photometer For The First Time; Setting The Language - wtw photoLab 6100 VIS Manual

Commissioning
18

3.2.3 Switching on the photometer for the first time

During the initial commissioning, the photometer automatically guides you
through the setting of the meter language, date and time after switching on
(see following sections).
Language
Deutsch ✓
English
Français
Español
Italiano
Bulgarian/Български
Česko
Chinese/ 中文
Traditional Chinese/ 繁體中文
Greek/Ελληνικά
Indonesian/Indonesia
When the initial commissioning is completed, the photometer displays the
Home menu each time after it is switched on and after the self-test (see
section 4.1).
3.2.4

Setting the language

During the initial commissioning the photometer automatically guides you to
the setting of the meter language after switching on.
Language
Deutsch ✓
English
Français
Español
Italiano
Bulgarian/Български
Česko
Chinese/ 中文
Traditional Chinese/ 繁體中文
Greek/Ελληνικά
Indonesian/Indonesia
After the initial commissioning, you can change the language in the
General setup / Language menu at any time (see section 4.2.4).
1 Press <ON/OFF>.
16.04.07 9:52
The photometer is switched on.
The display switches to the setting
of the language (see section
3.2.4).
After the setting of the language
the photometer carries out the
self-test.
1 Select a language with <▲><▼>.
16.04.07 9:52
2 Confirm the selected language
with <START·ENTER>.
The language has been set.
The currently selected language is
marked by a tick.
The display switches to the setting
of the Date and Time (see section
3.2.5).
®
photoLab 6100 VIS
ba75847e01 08/2009