Relay outputs
Proceeding: setting an
output
6 - 4
6.2.3 Setting outputs
1
Open the SETTINGS menu with
w
2
Using
and
menu item (corresponding to sensor 1, 2 or 3).
3
Confirm the selection Set output with
The setting table of the output is displayed.
4
Edit the setting table as described in section 4.3.2.
Note
To accept all settings, you have to highlight the Save and quit menu
item at the lower end of the setting table and press
m
setting table via
,
ignored.
s
g
, select and confirm the Relay output Rx
e
/Quit or the Quit menu item, all changes are
System 182
.
g
.
g
. If you exit the
ba75504e07
04/2012