System 182
Connecting lines to the
terminal strip
ba75504e07
04/2012
11
Open the enclosure of the Universal Transmitter.
2
1
3
Fig. 3-31 Inserting lines
Note
The complete assignment of the terminal strip is shown in section 3.12.
12
Screw a cable gland (pos. 1 in Fig. 3-31) with the sealing ring
(pos. 2) into the enclosure below the respective connections.
13
Loosen the coupling ring (pos. 3).
14
Feed the line through the cable gland in the enclosure.
15
Connect the wires to the terminal strip. While doing so, pay
attention to the specifications on the label located under the
terminal strip.
16
Tighten the coupling ring (pos. 3).
Installation
3 - 39