wtw DIQ/S 182-MOD System Operating Manual page 46

Installation
3 - 32
Terminal
labeling:
X17 X16
L1 N
100...
240V AC
NETZ/MAINS
L N
Fig. 3-27 Line power connection.
Note
The complete assignment of the terminal strip is shown in section 3.12.
9 Connect phases L and N to the terminal strip. Make sure that
the cable assignment agrees with the specification on the
terminal label under the terminal strip.
10 Tighten the coupling ring (pos. 3 in Fig. 3-26).
Warning
No free wires must be allowed to project into the enclosure.
Otherwise, there is a danger that areas safe to contact could come
into contact with dangerous voltages. Always cut off any wires
that are not in use as closely as possible to the cable gland.
11 Close the enclosure of the Universal Transmitter.
System 182
ba75504e07 04/2012