wtw DIQ/S 182-MOD System Operating Manual page 117

System 182
Changing the
assignment of sensor
numbers
Creating the identical
assignment of sensor
numbers in several
systems
ba75504e07 04/2012
You want to change the assignment of sensor numbers to sensors in
an already running IQ S
1 Unplug all sensors from the IQ S
Note
When the inactive datasets are deleted, all settings for the sensors are
deleted as well.
2 Delete all inactive datasets in the list of sensors (see System
operating manual, chapter Deleting inactive datasets of
sensors).
3 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).
You want to install several identical IQ S
the same time, create the same sequence of sensor number
assignments to the sensors in all systems.
1 Carry out a system start without any sensors (see System
operating manual, chapter Installation).
2 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).
3 Repeat steps 1 and 2 for all other systems and, while doing so,
keep to exactly the same order when connecting the sensors.
N system.
ENSOR ET
ENSOR
ENSOR
Modbus connection
N .
ET
N systems and, at
ET
7 - 7