Connecting Iq Sensors - wtw DIQ/S 182-MOD System Operating Manual

Installation
General installation
instructions
Materials required
Connecting the SACIQ
cable to the Universal
Transmitter or
MIQ module
Connecting the sensor
to the connection cable
3 - 16

3.4.5 Connecting IQ sensors

Sensors can be connected to all free SENSORNET connectors in the
182 system. The Universal Transmitter
DIQ/S 182-MOD has two SENSORNET connections.
Observe the following points when attaching sensors to the system:
 The sum of all IQ S
SACIQ) in the system may be up to a maximum of 250.
 IQ S
ENSOR
minimum distance of 20 cm from other lines that carry a voltage
greater than 60 V.
 1 x SACIQ connection cable (see chapter 11 A
OPTIONS
 1 x cable gland with seal
The free end of the connection cable already has the sheath removed
in the factory and all the wires are fitted with wire end sleeves.
 Phillips screwdriver
Tools
 Small screwdriver.
The connection of the SACIQ cable to the terminal strip is described in
section 3.4.4 (see C
Caution
The SACIQ sensor connection cable may only be connected to the
SENSORNET connections. No wires of the cable may be
connected with an external electrical potential. Otherwise,
malfunctions could occur.
1 Remove the protective caps from the plug connections of the
IQ sensor and SACIQ sensor connection cable and keep them
safe.
2 Plug the socket of the SACIQ sensor connection cable onto the
plug head connector of the IQ sensor. At the same time, rotate
the socket so that the pin in the plug head connector (1) clicks
into one of the two holes in the socket.
3 Then, screw the coupling ring (2) of the IQ sensor connection
cable on the IQ sensor up to the stop.
N
ENSOR ET
N lines must always be installed separately at a
ET
)
ONNECTING THE CABLES
line lengths (SNCIQ, SNCIQ/UG and
CCESSORIES AND
, Seite 13).
ba75504e07
System 182
04/2012