wtw DIQ/S 182-MOD System Operating Manual page 81

System 182
Inactive sensor datasets
Proceeding: deleting
inactive datasets
ba75504e07 04/2012
8 Edit the setting table as described in section 4.3.2.
Note
To accept all settings, you have to highlight the Save and quit menu
item at the lower end of the setting table and press
m
setting table via ,
ignored.
An inactive dataset for an IQ sensor arises if the Universal Transmitter
receives no signals from an already registered IQ sensor. The Error
display appears on the measured value display instead of a measured
value.
An inactive dataset can be reactivated by assigning it, e.g. to an IQ
sensor of the same type (see section 9.3.2). All settings are retained. If
you no longer require these data, you can erase them. All the settings
belonging to this IQ sensor as well as any links with outputs are deleted
by this action.
1 Open the SETTINGS menu with
w
2 Using and
item (corresponding to sensor 1 or sensor 2).
If the dataset is inactive the following display appears:
3 Select Delete dataset with
The dialog window for the security prompt appears.
4 Select Delete dataset with
The inactive sensor is erased.
e
/Quit or the Quit menu item, all changes are
s
g
Sensor, select and confirm the S0x menu
d
and confirm with
d
and confirm with
The SETTINGS menu
g
. If you exit the
.
g
.
g
.
5 - 3