Table of Contents
Advertisement
Parameter-
static.network.pppoe.password
Description
Default Value
Range
Example
Internet and PC Ports Transmission Methods
Internet Port Transmission Method
Parameter-
static.network.internet_port.speed_
duplex
Description
Default Value
Range
Example
PC Port Transmission Method
Parameter-
static.network.pc_port.speed_duple
x
762
Configuration File
<MAC>.cfg
Configures the PPPoE password when the Internet port
type is configured as PPPoE and the IP address mode is
configured as IPv4 or IPv4&IPv6.
Note: If you change this parameter, the IP phone will
reboot to make the change take effect.
Blank
String within 99 characters
static.network.pppoe.password = matrix
Configuration File
<MAC>.cfg
Configures the transmission method of Internet port.
Note: You can set the transmission speed to 1000Mbps/
Auto Negotiate to transmit in 1000Mbps if the IP phone
is connected to the switch supports Gigabit Ethernet.
We recommend that you do not change this parameter.
If you change this parameter, the IP phone will reboot
to make the change take effect.
0
Valid values are:
0-Auto negotiate
1-Full duplex, 10Mbps
2-Full duplex, 100Mbps
3-Half duplex, 10Mbps
4-Half duplex, 100Mbps
5-Full Duplex 1000Mbps
static.network.internet_port.speed_duplex = 0
Configuration File
<MAC>.cfg
Matrix SPARSH VP710 User Guide
Advertisement
Table of Contents
