Endress+Hauser Proservo NMS83 Operating Instructions Manual page 276

Operating menu
Output out of range
Navigation
Description
Selection
Factory setting
Additional information
High stop level
Navigation
Description
User entry
Factory setting
Additional information
Low stop level
Navigation
Description
User entry
Factory setting
276
"Safety settings" submenu
Navigation  Setup → Advanced setup → Safety settings
 Setup → Advanced setup → Safety settings → Output out range
Selection of behavior when displacer reached High stop level (→  171), Low stop level
or Reference position.
• Last valid value
• Alarm
Last valid value
Read access
Write access
 Setup → Advanced setup → Safety settings → High stop level
Position of the displacer high stop as measured from defined zero position (tank bottom or
datum plate).
–999 999.9 to 999 999.9 mm
Dependent on the device version
Read access
Write access
 Setup → Advanced setup → Safety settings → Low stop level
Position of the displacer low stop as measured from defined zero position (tank bottom or
datum plate).
–999 999.9 to 999 999.9 mm
0 mm
Operator
Maintenance
Operator
Maintenance
Proservo NMS83



Endress+Hauser