Endress+Hauser Proservo NMS83 Operating Instructions Manual page 194

Operating menu
User entry
Factory setting
Additional information
Maximum probe temperature
Navigation
Prerequisite
Description
User entry
Factory setting
Additional information
Probe position
Navigation
Prerequisite
Description
User entry
Factory setting
Additional information
194
–213 to 927 °C
–100 °C
Read access
Write access
 Setup → Advanced setup → Input/output → Analog IP → Max. probe temp
Operating mode (→  191) = RTD temperature input
The maximum approved temperature of the connected probe.
–213 to 927 °C
250 °C
Read access
Write access
If the temperature rises above the value entered in this parameter, the W&M status will be
"invalid".
 Setup → Advanced setup → Input/output → Analog IP → Probe position
Operating mode (→  191) = RTD temperature input
The position of the temperature probe (measured from the datum plate).
–5 000 to 30 000 mm
5 000 mm
Read access
Write access
This parameter, in conjunction with the measured level, determines whether the
temperature probe is still covered by the product. If this is no longer the case, the status of
the temperature value will be "invalid".
Operator
Maintenance
Operator
Maintenance
Operator
Maintenance
Proservo NMS83


Endress+Hauser