Endress+Hauser Proservo NMS83 Operating Instructions Manual page 240

Tank gauging
Hide thumbs Also See for Proservo NMS83:
Table of Contents

Advertisement

Operating menu
Liquid temp source
Navigation
Description
Selection
Factory setting
Additional information
Liquid temperature
Navigation
Description
Additional information
240
"Temperature" submenu
Read access
Navigation
 Setup → Advanced setup → Application → Tank config
 Setup → Advanced setup → Application → Tank config → Temperature → Liq temp
source
Defines source from which the liquid temperature is obtained.
• No input value
• HART device 1 ... 15 temperature
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
No input value
Read access
Write access
 Setup → Advanced setup → Application → Tank config → Temperature → Liquid
temp.
Shows the average or spot temperature of the measured liquid.
Read access
Write access
Depending on the connected temperature probe this parameter shows an average or
spot temperature.
Maintenance
→ Temperature
Operator
Maintenance
Operator
-
Proservo NMS83
Endress+Hauser

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Proservo NMS83 and is the answer not in the manual?

Table of Contents