Endress+Hauser Proservo NMS83 Operating Instructions Manual page 265

Proservo NMS83
Additional information
Safety distance
Navigation
Description
User entry
Factory setting
Additional information
Hysteresis
Navigation
Description
User entry
Factory setting
Additional information
Water density
Navigation
Description
User entry
Endress+Hauser
Read access
Write access
If the pressure P1 falls below the limit defined in this parameter, the density retains its last
value or the manual value is used instead.
 Setup → Advanced setup → Application → Tank calculation → HTMS → Safety
distance
Defines the minimum level which must be present above the bottom pressure sensor
before its signal is used for the calculation.
0 to 10 000 mm
2 000 mm
Read access
Write access
 Setup → Advanced setup → Application → Tank calculation → HTMS → Hysteresis
Defines the hysteresis for the HTMS calculation. Prevents constant switching if the level is
near the switch-over point.
0 to 2 000 mm
50 mm
Read access
Write access
 Setup → Advanced setup → Application → Tank calculation → HTMS → Water
density
Density of the water in the tank.
Signed floating-point number
Operator
Maintenance
Operator
Maintenance
Operator
Maintenance
Operating menu



265