Endress+Hauser Proservo NMS83 Operating Instructions Manual page 243

Proservo NMS83
Observed density source
Navigation
Description
Selection
Factory setting
Additional information
Density value
Navigation
Description
Additional information
Air density
Navigation
Description
User entry
Factory setting
* Visibility depends on order options or device settings
Endress+Hauser
"Density" submenu
Navigation  Setup → Advanced setup → Application → Tank config
 Setup → Advanced setup → Application → Tank config → Density → Density source
Determines how the density is obtained.
• HTG
• HTMS
• Average profile density
• Upper density
• Middle density
• Lower density
Dependent on the device version
Read access
Write access
 Setup → Advanced setup → Application → Tank config → Density → Density value
Shows the measured or calculated density.
Read access
Write access
 Setup → Advanced setup → Application → Tank config → Density → Air density
Defines the density of the air surrounding the tank.
0.0 to 500.0 kg/m³
1.2 kg/m³
→ Density
*
Operator
Maintenance
Operator
-
Operating menu


243