Hitachi U-5100 Instruction Manual page 319

Error Message
Xe Lamp Error Abnormality is found
when turning on the
lamp.
Error occurred Wavelength
when WL was initialization is
initialized abnormal.
WL Motor Error Wavelength
initialization is
abnormal.
WL CALIB. Error Abnormality is found in
wavelength calibration
with the bright line of
lamp.
WL Correction Abnormality is found in
Error wavelength correction.
Data Save Error RAM does not work
normally.
6 Cell Initialize Initialization of 6-cell
Error holder position is
abnormal.
6 Cell Move Error Abnormality is found in
detection of cell
position.
6 - 11
Cause
Turn on the lamp again.
If no improvement can be
seen, contact the
maintenance service
company authorized by
Hitachi High-
Technologies.
Retry wavelength
initialization. If no
improvement can be
seen, contact the
maintenance service
company authorized by
Hitachi High-
Technologies.
Retry wavelength
initialization. If no
improvement can be
seen, contact the
maintenance service
company authorized by
Hitachi High-
Technologies.
Retry wavelength
calibration. If no
improvement can be
seen, contact the
maintenance service
company authorized by
Hitachi High-
Technologies.
Retry wavelength
correction. If no
improvement can be
seen, contact the
maintenance service
company authorized by
Hitachi High-
Technologies.
Retry data saving. If no
improvement can be
seen, contact the
maintenance service
company authorized by
Hitachi High-
Technologies.
Mount this holder
properly and retry
initialization. Or if any
holder other than the 6-
cell holder is used, set 6-
cell condition, referring to
section 2.5.4..
Check the sample
compartment to see if
there is anything that
hinders rotation of 6 cells.
6.8
(cont'd)
Remedy