Hitachi U-5100 Instruction Manual page 167

(3) The standard measurement screen (Fig. 3-64) appears.
At this time, the cell position shifts to cell 1.
For measurement at a different position, hold down the
[SHIFT] key and press the [◄] or [►] to shift the cell
position. Make sure that the aimed-at cell number is
indicated on the screen.
In 6-cell manual mode, the photometric value at
NOTE:
the cell position indicated on the screen is
measured. Before measurement, therefore,
check if the cell position where the standard has
been set coincides with the cell position
indicated on the screen.
GUIDE: In 6-cell manual mode, the photometric value at
the cell position indicated on the screen is
measured. For carrying out auto zero
frequently, it is recommended to use cell 1.
Cell 1 can move to the position of cell A in a short
time, thus ensuring smooth measurement.
When the guidance is displayed, auto zero can
be executed at the position of cell A by pressing
the [AUTOZERO] key. After execution of auto
zero, the system moves to the cell position before
the execution. By pressing the [AUTOZERO]
with the auto zero sample set to cell A and the
sample set to cell 1, you can execute auto zero
without taking the cell in and out.
Photometry
ID
STD1
STD2
STD3
START:Meas.STD1：＿
Example of display with "3" set for
number of standards
Fig. 3-64 Standard Measurement Screen
3 - 103
CELL 1
ABS CONC
0.000
10.00
20.00
3.3.1
Cell
position