Hitachi U-5100 Instruction Manual page 140

3.2 Automatic Continuous Measurement (6-cell auto mode)
(2) During measurement, the screen shown in Fig. 3-45 is
displayed.
Photometry
ID
3 WL1 （ 260.0nm）
WL2 （ 280.0nm）
ABS DIFF=
ABS Ratio=
Meas.Sample3...
Fig. 3-45 Screen Displayed during Sample
Measurement
(3) When "6" or more is specified for "No. of Sample", the
results obtained from measurement of samples 1 to 5
are indicated as shown in Fig. 3-46. This
measurement result screen also appears after
completion of 2nd/3rd-round measurement.
Pressing the [START] key displays the next sample
setting screen. Set the next samples according to the
guidance. (Pressing the <1> key (Remeasure) allows
remeasurement of the previous sample.)
Photometry
ID
3 WL1 （ 260.0nm）
WL2 （ 280.0nm）
ABS DIFF= 0.155
ABS Ratio= 1.582
START:Continue; Select function.:＿
□ Remeasure
1
Fig. 3-46 Example of Display after 1st-round
Sample Measurement
(4) When the specified number of samples have all been
measured, the screen shown in Fig. 3-47 appears.
For the processing function assigned to each key, refer
to Table 3-34.
3 - 76
280.0nm 0.268ABS CELL A
ABS
CELL A
ABS
0.423
0.268