Hitachi U-5100 Instruction Manual page 268

4.6 Introduction and Mounting Method of Separately Available Options
(2) Only one screw is used for fastening both the sample
compartment and single cell holder. Tighten the
screw firmly using a Phillips screwdriver.
Fig. 4-68 Mounting Single Cell Holder in Sample
Compartment
(3) Holder mounting is now completed. Close the lid of
the sample compartment.
Fig. 4-69 View After Mounting the Single Cell Holder
3. Change of 6-cell Mode Setting
The 6-cell mode setting needs to be changed.
Turn the 6-cell mode setting from ON to OFF, referring to
section 2.5.4.
Carry out measurement, after referring to section 4.6.5.
4 - 54
Screw