Hitachi U-5100 Instruction Manual page 157

(5) Return to the WL Scan screen by pressing the
[RETURN] key.
9. Setting and Measurement of Samples
(1) To determine the measuring conditions set in the
preceding steps, press the <8> key (Meas. Screen)
and then [ENTER] key. Or press the [MEAS.
SCREEN] key.
(2) The guidance on sample setting (Fig. 3-30) appears.
On the screen, displayed from the left are the cell
number and sample name. Cell A is used for baseline
correction. Set a baseline correction sample (blank)
to cell A. And set the corresponding samples to cells
1 to 5. Upon completion of setting, press the [START]
key. After baseline correction with cell A, sample 1
will be measured.
WL Scan
[Info]
Set samples to Cell No..
Cell A Blank
Cell 1 Sample1
Cell 2 Sample2
Cell 3 Sample3
Cell 4 -
Cell 5 -
START:Meas.Baseline and Sample1.: _
Fig. 3-58 Guidance on Sample Setting
10. Measurement of Sample Solutions
(1) Upon completion of sample 1 measurement, the
guidance shown in Fig. 3-59 appears. To record data,
perform the save or print operation. To save data,
select the <3> key (Save). To print data, press the
[PRINT] key. Pressing the <1> to <5> keys allows the
processings shown in Table 3-41. For proceeding to
the next measurement, press the [START] key.
3 - 93
CELL A
3.2.4